5 Pins JoyStick Breakout Board Sensor Module For Robot Arduino UNO 2560 R3 STM32

Description

Home
Arduino
Module
Sensor
Chips
About Us
Description:
This is a breakout module for Playstation2 analog joystick.
There are 5 pins on board: VCC, GND, X, Y and Button.
Connect the module with 5V power suppy with VCC and GND, you can read out the joystick status by X,Y and button pins.
When using the 5V power supply, the default analog output for X,Y is 2.5V.
With the direction of the arrow, the voltage up to 5V, and the opposite direction down to 0V.
Package Included:
1 x 5 Pins JoyStick Breakout Board Module Sensor Shield For Robot Arduino UNO 2560 R3 STM32
Payment
Shipping
Refund
Payment
We accept PayPal only.
But we only
Accept
your
Ebay Address
,Please Make sure it's 100% right.
Payment must be received in 5 business days of auction closing.
Please leave note for your special request (e.g. Colors or Size) in PayPal when you pay the order.
Any special request cannot be accepted after 24 hours of payment, because most of orders will be processed instantly and same day dispatched.
Shipping
Fill your shipping info
Refund
All package need to
wait 30 days
(US only n
eed 7-10 days)
,
Please take care it.Less than 30 days,we can't take a refund
.
If the item is defect when you receive it or you are not satisfied with it, please return it within 14 days for a replacement or money back. But the items must be back in factory condition. Please contact us and double check the return address before you return it.
If is item is defective in 12 months, you can return it to us. We will send you a new replacement after receiving the defective item.